Module out of range [ERROR 166]

Module out of range [ERROR 166]

Module 42 out of range (0-32) for Module 1,01,02 Block 1234 (FC 37)

This message means that the value of a module was smaller or larger than the allowed value range.

A common cause is that S2 is the intended value for the module and S1 is intended block value.

This error can trigger other errors:

Module 8713 out of range for Module 2,50,04 Block 1699 (FC 121).
Module 8605 out of range for Module 2,50,04 Block 1698 (FC 121).
Internal error in LPMToString: module 713 out of range

Note that 713 is the lower part of the specious value of S1=module=8713. Correcting the value of S1 and S2 (swapping them) will fix the Internal error, too.

No tool error reports 50.png

Module must be between 0-32.

Error 166.png

This message is likely to show an error in the system configuration. It should be reviewed. The issue raised may be in unused logic or graphics, or have other realities that make it a non-issue.

Please contact us for help resolving your error messages.